Network Deployment - Vivotek Network Camera FD7141(V) User Manual

VIVOTEK - A Leading Provider of Multimedia Communication Solutions
Ceiling mount without the bottom base (Embedded)
1� Attach the supplied Ceiling Hole Template Sticker to the wall�
2� Dig a hole along the inner circle of the sticker�
3. Through the 3 circles on the sticker, drill 3 pilot holes into the ceiling. Then hammer the sup-
plied three plastic anchors into the holes�
4� Mount the Network Camera to the ceiling and feed the cables�
5. Through the three holes on the side of the camera base, insert the supplied three screws to
corresponding holes and secure them with a screwdriver�
1
Drill hole
Ceiling Hole Template Sticker

Network deployment

Setup the Network Camera over the Internet
This section explains how to configure the Network Camera to Internet
1. If you have external devices such as sensors and alarms, make connection from general I/O
terminal block�
2� Use the supplied RJ45 female/female coupler to connect the Network Camera to a switch.
Use Catagory 5 Cross Cable when Network Camera is directly connected to PC�
3� Connect the power cable from the Network Camera to a power outlet�
1
N�C�: No Connector
N.C.
N�C�: No Connector
N.C.
N�C�: No Connector
N.C.
AC24V
AC24V: Power in AC 24V
AC24V
AC24V: Power in AC 24V
GND: Ground
GND
D I : Digital Input
DI
DO
D O : Digital Output
+12V
+12V : Power, 12V DC
10 - User's Manual
3
2
4
connection�
5
2
3