Table of Contents
Advertisement
3. ADJUSTMENTS
SHIP'S SPD/BR
Choose the source of speed and course data with which to draw ship's track.
1. Rotate the [RANGE] control to select SHIP'S SPD/BR.
2. Rotate the [GAIN] control to choose item appropriately.
LOG GYRO:
CURRENT:
NAV DATA:
GYRO+NAV:
LOG PULSE
Choose log pulse/mile specification of speed signal from the LOG port, 200 or 400
pulse/mile.
1. Rotate the [RANGE] control to select LOG PULSE.
2. Rotate the [GAIN] control to choose 200 or 400.
PORT 1 BAUDRATE, PORT 2 BAUDRATE
Set baud rate of equipment connected to NMEA1/CIF1 or NMEA2/CIF2 port, among
2400, 4800, 9600 and 19200 (bps).
1. Rotate the [RANGE] control to select PORT 1 BAUDRATE or PORT 2 BAU-
DRATE appropliately.
2. Rotate the [GAIN] control to choose item among 2400, 4800, 9600 and 19200.
3-4
Use data from the speed log connected to LOG port as ship's
speed, data from gyrocompass connected to GYRO port as
ship's course.
Use data from the current indicator connected to NMEA1/CIF1 or
NMEA2/CIF2 port.
Use data from the equipment (set at [NAV DATA] described on
next page) connected to NMEA/CIF 1 or NMEA/CIF 2 port.
Use heading data signal from the sensor connected to the GYRO
port for course, data from the equipment (set at [NAV DATA] de-
scribed on next page) or current indicator connected to NMEA/
CIF 1 or NMEA/CIF 2 port for the ship's speed. When using data
from the current indicator (for positioning) for ship's speed, set
DIP switch #2-2 in the transceiver unit to ON.
MAIN Board
S2
S3
Location of DIP switch S2
Advertisement
Table of Contents
