Changing the cable entrance location
1. Unfasten six screws (M4 8) at the bottom of the control unit.
2. Unfasten two screws (M4 10) fixing the cable clamp.
Discard these screws.
3. Unplug connectors from J1 and J2 on the KEY Board 10P6951.
4. Attach the cable clamp removed at step 2 and 3 with two screws, spring washers,
flat washers and nuts (supplied with accessories) to fix the control cable as shown
in the illustration below.
Cable clamp
Fix the cable with cable clamp here.
5. Reattach connectors J1 and J2 removed at step 3.
6. Fasten six screws to assemble the control unit.
Default hole location
Screws
M4×8 (8 pcs.)
Control unit
Changing the cable location
Remove this cable clamp.
J1
Remove these two connectors.
Default hole location
Screws
M4×8 (8 pcs.)
Nut
Spring washer
Flat washer
Screw (M4×12)
1. MOUNTING
J2
1-15