Table of Contents
Advertisement
2. WIRING
Run cables through this space.
3. Pass the transducer cable (12 cores) and TX cable through the cable clamp. Note
that the transducer cables should be arranged as shown below and clamped at
the point of marking.
5
1
12
9
4
8
4. Pass the hull and RX (168 cores) cables through the cable clamp, and tighten the
cable clamp.
5. Run the RX cable as shown below and plug in the connectors.
Pass the RX cable under the board.
Fix the wires to the board
with cable ties.
6. Plug in the slip-on lugs of transducer cables
2-6
Cable tie
P2
P1
Transducer cable connection
3
7
RX
11 10
6
2
HULL
Preamplifier unit, cable clamp
RX cable connection
Note: Cable and connection
numbers are marked on the
side of each connector as
shown below.
Slip-on lug
TX
Clamp point
marking
Note: Cable and connector
numbers are marked on the
side of each connector as
shown below.
to
2
-P1
1
Connector No.
Cable No.
Cable clamp
Transducer cable
1
-P1
Connector No.
Cable No.
.
3
Advertisement
Table of Contents
