Table of Contents
Advertisement
3. Wrap the sheath end with vinyl tape to pass the cable through the main shaft, and
then remove sheath of transducer cable at the length of "main shaft length +
70 mm."
4. After screwing the transducer into main shaft, fasten two socket-set screws
(M6 10, supplied) to fasten the main shaft to the transducer.
Note: The transducer should be screwed into the main shaft by 50 mm.
Rotate transducer
to screw it into
main shaft.
Socket-set screw
M6 × 10, 2 pcs.
Main shaft length + 70 mm
Transducer cable
Grease shaft 50 mm.
Hold this portion
with pipe wrench.
Installing transducer
Use suitable roller knife to cut sheath.
When it is difficult to pass the
transducer cables through the
flat washers, gasket and the
cable gland, unbind the
transducer cables and pass
them one by one.
1. MOUNTING
Gasket
Cable gland
Flat
washer
1-5
Advertisement
Table of Contents
