Table of Contents
Advertisement
2.3.1
Connecting TX cable
The connector numbers are marked on respective 2P plugs (12 pcs.) of the TX cable.
Connect them to the transceiver unit, referring to the sticker on the PCB fixing plate.
The ground wire should be connected to the chassis as shown below.
Connector No.
TX cable
2.3.2
Connecting RX cable
The connector numbers are marked on respective plugs. Connect them referring to
the instruction at the back of the front panel of the transceiver unit.
Note: CN-B41C/CN-B41D are provided on the both PAMP Boards and you may use
either side.
Processor
cable
PCB fixing plate
Ground wire
Transceiver unit
Connecting of Processor and RX cables
RX
cable
2. WIRING
2-9
Advertisement
Table of Contents
