Table of Contents
Advertisement
[REMOTE2 MODE]
You can set the <REMOTE 2 IN> terminal.
1)
Press as to select [REMOTE2 MODE].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT]
[USER]
f When [USER] is selected, proceed to Step 3).
3)
Press the <ENTER> button.
4)
Press as to select one from [PIN2] to [PIN8], and press qw to switch the setting.
[FUNCTION BUTTON]
Set the function of the <FUNCTION> button on the remote control.
1)
Press as to select [FUNCTION BUTTON].
2)
Press the <ENTER> button.
f The [FUNCTION BUTTON] screen is displayed.
3)
Press as to select a function.
[DISABLE]
[P IN P]
[SUB MEMORY]
[SYSTEM SELECTOR]
[SYSTEM DAYLIGHT VIEW]
[FREEZE]
[WAVEFORM MONITOR]
[LENS MEMORY LOAD]
[LEFT/RIGHT SWAP]
[PROJECTION METHOD]
4)
Press the <ENTER> button.
[STATUS]
Display the status of the projector.
1)
Press as to select [STATUS].
2)
Press the <ENTER> button.
f The [STATUS] screen is displayed.
3)
Press qw to switch the pages.
f The page will change each time you press the button.
[PROJECTOR TYPE]
[SERIAL NUMBER]
[PROJECTOR RUNTIME]
[LIGHT RUNTIME]
Chapter 4 Settings — [PROJECTOR SETUP] menu
Uses pin assignment of the <REMOTE 2 IN> terminal in standard setting. (x page 255)
Changes the setting of the <REMOTE 2 IN> terminal.
Disables the <FUNCTION> button.
Switches the [P IN P] setting ([OFF], [USER1], [USER2], or [USER3]). (x page 178)
Displays the sub memory list. (x page 183)
Switches the [SYSTEM SELECTOR] setting according to the input signal of the image being
projected.
f When the input signal is anything other than SDI1 input or SDI2 input
The [PICTURE] menu → [SYSTEM SELECTOR] (x page 99)
f When the input signal is SDI1 input or SDI2 input
g The [DISPLAY OPTION] menu → [SDI IN] → [SINGLE LINK SETTING] → [SDI1]/[SDI2] →
[SYSTEM SELECTOR] (x page 135)
g The [DISPLAY OPTION] menu → [SDI IN] → [DUAL LINK SETTING] → [SYSTEM SELECTOR]
(x page 135)
Switches the [SYSTEM DAYLIGHT VIEW] setting. (x page 96)
Temporarily pauses the image. (x page 143)
Displays the waveform of the input signal. (x page 143)
Loads the registered lens memory. (x page 148)
Switches the [LEFT/RIGHT SWAP] setting. (x page 119)
Switches the [PROJECTION METHOD] setting. (x page 145)
Displays the type of the projector.
Displays the serial number of the projector.
Displays the runtime of the projector.
Displays the runtime of the light source 1 and the light source 2.
ENGLISH - 173
Advertisement
Table of Contents
