Table of Contents
Advertisement
2)
Press the <ENTER> button.
f The [Art-Net] screen is displayed.
3)
Press as to select [Art-Net SETUP].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON(2.X.X.X)]
[ON(10.X.X.X)]
[ON(MANUAL)]
f Proceed to Step 5) when anything other than [OFF] is selected.
5)
Press the <ENTER> button.
f The [Art-Net SETUP] screen is displayed.
6)
Press as to select an item, and press qw to switch the setting.
[NET]
[SUB NET]
[UNIVERSE]
[START ADDRESS]
7)
Press as to select [STORE], and press the <ENTER> button.
f The confirmation screen is displayed.
8)
Press qw to select [OK], and press the <ENTER> button.
Note
f If [ON(2.X.X.X)] or [ON(10.X.X.X)] is selected, IP address is calculated and set automatically.
[Art-Net CHANNEL SETTING]
Set the assignment of the channel. Make settings to use the Art-Net function.
For the channel definitions used for controlling the projector with the Art-Net function, refer to "Using Art-Net
function" (x page 242).
1)
Press as to select [Art-Net].
2)
Press the <ENTER> button.
f The [Art-Net] screen is displayed.
3)
Press as to select [Art-Net CHANNEL SETTING].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[2]
[3]
*1
[USER]
[1]
*1 This item can be set in following case.
When the standard DC motor unit installed in the Zoom Lens (Model No.: ET-D75LE6, ET-D75LE8, ET-D75LE10, ET-D75LE20, ET-D75LE30,
ET-D75LE40, etc.) is replaced with the stepping motor unit using the Stepping Motor Kit (Model No.: ET-D75MKS10), or when a projection
lens with the stepping motor is attached.
f Proceed to Step 6) when anything other than [USER] is selected. The function assigned to the channel is
displayed by pressing the <ENTER> button.
f When [USER] is selected, proceed to Step 5).
5)
Press the <ENTER> button.
f The [Art-Net CHANNEL SETTING] screen is displayed.
196 - ENGLISH
Chapter 4 Settings — [NETWORK] menu
Disables the Art-Net function.
Enables the Art-Net function and sets the IP address to 2.X.X.X.
Enables the Art-Net function and sets the IP address to 10.X.X.X.
Enables the Art-Net function and uses the IP address set in [WIRED LAN].
Enter [NET] to be used when the projector processes Art-Net.
Enter [SUB NET] to be used when the projector processes Art-Net.
Enter [UNIVERSE] to be used when the projector processes Art-Net.
Enter [START ADDRESS] to be used when the projector processes Art-Net.
Uses the channel assignment in standard setting.
Uses the channel assignment with the setting that can numerically control the lens position.
Changes the channel assignment.
Uses the channel assignment with DZ21K series compatible.
DZ21K series: DZ21K series, DS20K series, DW17K series, DZ16K series
Advertisement
Table of Contents
