Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
When using the power cord without the lock button
1)
Confirm that the <MAIN POWER> switch on the side of the projector is on the <OFF> side, and
remove the power plug from the outlet.
2)
Raise the power cord holder fixing the power cord upward. (Fig. 1)
f Fix the power cord holder by snapping into the projector.
3)
While holding the power cord connector, pull out the power cord from the <AC IN> terminal of the
projector. (Fig. 2)
Power indicator
Indicate the status of the power. Check the status of the power indicator <ON (G)/STANDBY (R)> before operating
the projector.
Indicator status
Off
Red
Green
Orange
Note
f While the power indicator <ON (G)/STANDBY (R)> lights in orange, the fan is running to cool the projector.
f For approximately 15 seconds after the projector is switched off, the indicator does not light up even if the power is switched on. Turn on the
power again after the power indicator <ON (G)/STANDBY (R)> lights in red.
f The projector consumes power even in standby mode (power indicator <ON (G)/STANDBY (R)> lit in red). Refer to "Power consumption"
(x page 269) for the power consumption.
f When the projector receives the signal from the remote control, the power indicator <ON (G)/STANDBY (R)> will blink in the following color
according to the status of the projector.
g When the projector is in projection mode: Green
g When the projector is in standby mode: Orange
However, if the [PROJECTOR SETUP] menu → [STANDBY MODE] is set to [ECO], the indicator will stay lit in red and will not blink if the
projector is in standby mode.
f The power indicator <ON (G)/STANDBY (R)> will blink slowly in green while the shutter function is in use (shutter: closed), or while the
function of the [PROJECTOR SETUP] menu → [NO SIGNAL LIGHTS-OUT] (x page 165) is operating and the light source is turned off.
f If the power indicator <ON (G)/STANDBY (R)> is blinking in red, consult your dealer.
60 - ENGLISH
Fig. 1
Power indicator <ON (G)/STANDBY (R)>
The main power is switched off.
The power is switched off. (standby mode)
Projection will start when the power on <b> button is pressed.
Lit
f The projector may not operate when the light source indicators <LIGHT1>/<LIGHT2>
or the temperature indicator <TEMP> are blinking. (x page 231)
Lit
Projecting.
The projector is preparing to switch off the projector.
Lit
The power is switched off after a while. (Changes to the standby mode.)
Fig. 2
Projector status
Advertisement
Table of Contents
