Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
11) Press the <ZOOM> button again to adjust the zoom and match the projected image size to the screen.
Note
f When the projector is switched on for the first time after purchase, as well as when the [PROJECTOR SETUP] menu → [INITIALIZE] →
[ALL USER DATA] is executed, the focus adjustment screen is displayed after projection starts, and then the [INITIAL SETTING] screen is
displayed. For details, refer to "When the initial setting screen is displayed" (x page 62).
Switching off the projector
3)
1)
Press the power standby <v> button.
f The [POWER OFF(STANDBY)] confirmation screen is displayed.
2)
Press qw to select [OK], and press the <ENTER> button.
(Or press the power standby <v> button again.)
f Projection of the image will stop, and the power indicator <ON (G)/STANDBY (R)> on the projector body
lights in orange. (The fan keeps running.)
3)
Wait for a few seconds until the power indicator <ON (G)/STANDBY (R)> of the projector body lights
up in red (fan is stopped).
4)
Press the <OFF> side of the <MAIN POWER> switch to turn off the power.
Attention
f When switching off the projector, make sure to follow the procedures described. Failure to do so may damage the internal components and
result in malfunctions.
Note
f For approximately 15 seconds after the projector is switched off, the indicator does not light up even if the power is switched on.
f Even when the power standby <v> button is pressed and the projector is switched off, the projector consumes power if the main
power of the projector is on.
When the [PROJECTOR SETUP] menu → [STANDBY MODE] is set to [ECO], use of some functions is restricted, but the power
consumption during standby can be conserved.
70 - ENGLISH
4)
1)
1)
2)
2)
Advertisement
Table of Contents
