Table of Contents
Advertisement
3)
Press the <ENTER> button on the control panel.
f It will go into an IP address setting mode (where the self-diagnosis display is blinking in 0.5 second
intervals).
f It will not go into the IP address setting mode even if the <ENTER> button on the remote control is pressed.
4)
Press asqw to enter the IP address.
f Press qw to switch the display of the IP address in the self-diagnosis display. Press qw to display the
address to change, and then press as or the number (<0> - <9>) buttons to set the address.
f Once all the addresses are entered, proceed to Step 5).
5)
Press the <ENTER> button on the remote control or control panel.
f [IP ADDRESS] is set to the entered IP address.
f The setting is reflected to the [NETWORK] menu → [WIRED LAN] → [IP ADDRESS].
f The IP address setting mode is canceled when the <ENTER> button is pressed, and the settings are
displayed in the self-diagnosis display in two second intervals as follows. Next display is an example when
[IP ADDRESS] is set to 192.168.0.10.
"192"
Note
f The IP address setting mode is canceled when no setting operation is performed for 10 seconds or longer in the IP address setting mode.
f The IP address will be set to the following factory default setting when the <DEFAULT> button on the remote control is press while in the IP
address setting mode.
[DHCP]
[IP ADDRESS]
258 - ENGLISH
Chapter 7 Appendix — Technical information
"168"
"000"
OFF
192.168.0.8
"010"
Display end
Advertisement
Table of Contents
