Table of Contents
Advertisement
r When [DHCP] is set to [ON]
This is an example when the [NETWORK] menu → [WIRED LAN] → [DHCP] is set to [ON], and [IP ADDRESS] is
set to 192.168.0.8.
"IPo"
r When the IP address cannot be acquired
This is when the IP address cannot be acquired from the DHCP server.
Setting the IP address
When using the DHCP server
IP address can be acquired automatically when there is a DHCP server in the network where the projector is to be
connected.
1)
Press the <ON> side of the <MAIN POWER> switch to turn on the power.
f The power indicator <ON (G)/STANDBY (R)> lights in red, and the projector enters the standby mode.
2)
Press and hold the <STATUS> button on the remote control for three seconds or more.
f Currently set IP address is displayed in the self-diagnosis display at the side of the projector.
3)
Press the <ENTER> button on the control panel.
f It will go into an IP address setting mode (where the self-diagnosis display is blinking in 0.5 second
intervals).
f It will not go into the IP address setting mode even if the <ENTER> button on the remote control is pressed.
4)
Press the <AUTO SETUP> button on the remote control or control panel.
f [DHCP] is set to [ON].
f The setting is reflected to the [NETWORK] menu → [WIRED LAN] → [DHCP].
f The IP address setting mode is canceled when the <AUTO SETUP> button is pressed, and the setting is
displayed in the self-diagnosis display for approximately two seconds.
Note
f The IP address setting mode is canceled when no setting operation is performed for 10 seconds or longer in the IP address setting mode.
f The IP address will be set to the following factory default setting when the <DEFAULT> button on the remote control is press while in the IP
address setting mode.
[DHCP]
[IP ADDRESS]
Specifying the IP address
Enter the IP address when there is no DHCP server in the network where the projector is to be connected.
1)
Press the <ON> side of the <MAIN POWER> switch to turn on the power.
f The power indicator <ON (G)/STANDBY (R)> lights in red, and the projector enters the standby mode.
2)
Press and hold the <STATUS> button on the remote control for three seconds or more.
f Currently set IP address is displayed in the self-diagnosis display at the side of the projector.
Chapter 7 Appendix — Technical information
"192"
"168"
"IPo"
"IPo"
OFF
192.168.0.8
"000"
"---"
Display end
Display end
"008"
Display end
ENGLISH - 257
Advertisement
Table of Contents
