Manufactured Home Requirements; Location - Superior Fireplaces DRL6500 Installation And Operation Instruction Manual

Innovative Hearth Products
DRL6500 Linear Direct-Vent Gas Fireplaces

MANUFACTURED HOME REQUIREMENTS

This appliance may be installed in an aftermarket, permanently located, manufactured home (USA only) or mobile
home, where not prohibited by local codes.
This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for
use with other gases, unless a certified kit is used.
Ensure that the cross members are not cut or weakened during installation. The structural
integrity of the manufactured home floor, wall, and ceiling / roof must be maintained.
This appliance must be grounded to the chassis of the manufactured home in accordance with
local codes or in the absence of local codes, with the National Electrical Code ANSI / NFPA
70—latest edition or the Canadian Electrical Code CSA C22.1—latest edition.

LOCATION

In selecting the location, the aesthetic and functional use of the fireplace are primary concerns. However, vent
system routing to the exterior and access to the fuel supply are also important. The fireplace may be located on or
near conventional construction materials. See Construct the Fireplace Framing on Page 18 for more information.
Due to high temperatures, the appliance should be located out of traffic and away from furniture and draperies.
The location should also be free of electrical, plumbing or other heating/air conditioning ducting.
Be aware that this is a heat producing fireplace. Objects placed above the unit are exposed to elevated temperatures.
Do not insulate the space between the fireplace and the area above it.
Figure 3 - Typical Locations and Venting
Top Vent
Recessed
Installation
12
Cet appareil peut être installé dans une maison préfabriquée (mobile) déjà installée à demeure si les règlements
locaux le permettent.
Cet appareil doit être utilisé uniquement avec le type de gaz indiqué sur la plaque signalétique. Cet appareil ne
peut être converti à d'autres gaz, sauf si une trousse de conversion est utilisée.
En raison des températures élevées, l'appareil devrait être installé dans un endroit où il y a peu de
circulation et loin du mobilier et des tentures.
Top Vent
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
CAUTION
CAUTION
VERTICAL VENT
(Rear Vent Application)
HORIZONTAL VENT
(Rear Vent Application with a chase)
General Information
900077-00, 01/2018
HORIZONTAL VENT
(Rear Vent Application without a chase)
VERTICAL VENT
HORIZONTAL VENT Vertical Vent
(Top Vent Application) (Top Vent Application)
(Top Vent)
VERTICAL VENT HORIZONTAL VENT
(Rear Vent Application) (Rear Vent Application without a chase)
VERTICAL VENT
HORIZONTAL VENT Horizontal Vent HORIZONTAL VENT
(Rear Vent Application with a chase) (Top Vent Application) (Top Vent Application)
(Top Vent)