Table of Contents
Advertisement
Innovative Hearth Products
DRL6500 Linear Direct-Vent Gas Fireplaces
Construct the Fireplace Framing
1.
IMPORTANT! BEFORE YOU BEGIN FRAMING, DETERMINE WHETHER YOU WILL BE INSTALLING THE
FIREPLACE AS A CLEAN FACE UNIT OR USING A SURROUND AND BEZEL. SEE PAGES 43 AND 44. WE
STRONGLY RECOMMEND WHEN THE FIREPLACE IS FRAMED WITH A 1/2" NONCOMBUSTIBLE BOARD,
WE RECOMMEND USING A SECOND LAYER, LOCALLY SOURCED, NONCOMBUSTIBLE BOARD SIMILAR
TO DUROCK
MUST BE OFFSET BACK SO THE TWO LAYER SURFACE WILL BE ON THE SAME PLANE AS THE WALLS
ON THE SIDES AND TOP OF THE FIREPLACE.
1. Frame the fireplace as illustrated in Table 10. All framing details must allow for a minimum clearance to combustible
2. Mount the fireplace on a fully supported base extending the full width and depth of the unit. If installed on combustible
NOTE: Headers may be in direct contact with the fireplace top standoff spacers when they are bent up vertically,
maintaining the 9-3/8" clearance to the fireplace top, but must not be supported by them or notched to fit around them.
All construction above the fireplace must be self-supporting. DO NOT use the fireplace for structural support.
18
OR HARDIBOARD
®
framing members as shown in Table 8. Steel studs are strongly recommended where exposed to heat.
materials, such as carpeting, vinyl tile, or combustible material other than wood flooring, the appliance shall be
installed on a metal or wood panel extending the full width and depth of the fireplace.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
. IF A SECOND LAYER OF BOARD IS USED, THE FIREPLACE FRAMING
®
Installation
900077-00, 01/2018
Advertisement
Table of Contents
