Dac5687 Evm Operational Procedure - Texas Instruments DAC5687 EVM User Manual

www.ti.com
2

DAC5687 EVM Operational Procedure

To prepare the DAC5687 EVM for operation, follow these steps:
1. Parallel Port Interface: Connect one end of the supplied serial interface cable to the parallel port of a
PC and the other end of the cable to J1 on the EVM and skip steps 2 to 7.
2. USB Interface: Connect the provided USB to SPI adapter board to the parallel port connector on the
EVM and to a spare USB port on the host PC using the supplied USB cable. The Windows Found New
Hardware Wizard should open; if this is not the case make sure the cable is connected properly. Select
"No, not this time" from the options available and then click "Next" to proceed with the installation.
SLWU017B – APRIL 2005 – Revised March 2007
Submit Documentation Feedback
DAC5687 EVM Operational Procedure
DAC5687 EVM 7