Table of Contents
Advertisement
Personal Protective Equipment (PPE) Required!
Failure to wear proper PPE for the job being undertaken could result in death or serious
injury. Technicians, in order to protect themselves from potential electrical, mechanical,
and chemical hazards, MUST follow precautions in this manual and on the tags, stickers,
and labels, as well as the instructions below:
•
Before installing/servicing this unit, technicians MUST put on all PPE recommended for
the work being undertaken. ALWAYS refer to appropriate MSDS sheets and OSHA
guidelines for proper PPE.
•
When working with or around hazardous chemicals, ALWAYS refer to the appropriate
MSDS sheets and OSHA guidelines for information on allowable personal exposure
levels, proper respiratory protection, and handling recommendations.
•
If there is a risk of arc or flash, technicians MUST put on all PPE in accordance with NFPA
70E or other country-specific requirements for arc flash protection, PRIOR to servicing
the unit.
Follow EHS Policies!
Failure to follow instructions below could result in death or serious injury.
•
All Trane personnel must follow the company's Environmental, Health and Safety
(EHS) policies when performing work such as hot work, electrical, fall protection,
lockout/tagout, refrigerant handling, etc. Where local regulations are more
stringent than these policies, those regulations supersede these policies.
•
Non-Trane personnel should always follow local regulations.
Copyright
This document and the information in it are the property of Trane and may not be used
or reproduced in whole or in part, without the written permission of Trane. Trane
reserves the right to revise this publication at any time and to make changes to its
content without obligation to notify any person of such revision or change.
Trademarks
All trademarks referenced in this document are the trademarks of their respective
owners.
Revision History
• Updated the literature number from X39641273001F to BAS-SVN208*-EN.
• Updated the Order number in the Front Cover.
• Updated the Tracer SC to System Controller throughout the document.
• Updated the Change UC400 to XM Module in the Step 10.
• Updated the Special Recommendations for Single Zone RTU Installations section
in the Step 11.
• Updated the Tracer ES to Tracer Ensemble in the Step 17.
• Updated the potential causes for up or down arrow are disabled problem in the
Troubleshooting and Common Questions section.
BAS-SVN208G-EN
WARNING
WARNING
3
Advertisement
Table of Contents
