Step 15: Powering The Display - Trane Tracer Concierge Installation Instructions Manual

Step 15: Powering the Display

1. Connect the Ethernet cable from System Controller Port 2 to the Tracer 10-inch
Display USB Port 1. Or alternatively for a Wi-Fi connection, connect the Ethernet cable
from System Controller Port 2 to the Wi-Fi router Port 1.
2. Plug in the display power adapter to an appropriate wall outlet.
3. If the display does not power up, then press the power switch on the back of the
display.
Figure 15. Back of the display
Power
button
Note: The actual locations of power button and ports may vary.
BAS-SVN208G-EN
Step 15: Powering the Display
17