Replacement Parts; Component Access; Draining The Appliance - Worcester Greenstar 2000 Installation And Maintenance Instructions Manual

Hide thumbs Also See for Greenstar 2000:
Table of Contents

Advertisement

10

Replacement parts

WARNING
Mains supplies - Isolate the appliance
▶ Turn off the gas supply and isolate the mains electrical supply before
starting any work and observe all relevant safety precautions.
▶ Drain the appliance/system where necessary and protect any
electrical equipment from water ingress during component
replacement.
WARNING
Component replacement:
▶ After replacement of a gas carrying component, where a gasket or
seal has been disturbed or replaced, check for gas tightness using a
gas sniffer/leak detection fluid.
▶ On re-assembly check all affected seals for cracks, hardness and
deterioration.
 If damaged or in any doubt the seal must be replaced.
▶ Also after re-assembly, carry out the following checks:
 Fan pressure.
 Flue gas analysis.
Only use Worcester, Bosch Group original spare parts with this
appliance. Non Worcester, Bosch Group original spare parts will
invalidate the guarantee (if applicable) and any warranty.
▶ A comprehensive list of appliance spares can be found on the website
www.worcester-bosch.co.uk/spares
10.1

Component access

Removing the front casing
The front casing is secured with two screws which are critical to maintain
the case seal and to prevent unauthorised removal (electrical safety).
▶ Always secure the casing with these screws.
▶ Loosen the two screws [1] and pull the bottom of the casing forward.
▶ Lift off the casing.
Fig. 89 Removing the front casing
Greenstar 2000 – 6 721 820 552 (2021/02)
10.2
Risk of scalding!
▶ Take care when draining down, hot residual water can represent a
Risk of water damage to appliance or property!
Damage from disconnecting water pathways which may have retained
some water.
▶ Take care after draining the appliance to protect equipment/property
Many of the tasks in this section require that the appliance be isolated
and drained. This will be indicated in the manual if required.
Refer to figure 90.
▶ Open the drain plug using a 8mm hex key; use a suitable container to
Fig. 90 Drain point
1

Draining the appliance

CAUTION
potential scalding risk
NOTICE
from residual water content within components.
collect any water.
Replacement parts
8mm
0010029499-001
67

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gr2300iw c

Table of Contents