Installation - Worcester Greenstar 2000 Installation And Maintenance Instructions Manual

5

Installation

NOTICE
Risk of damage to appliance or accessories.
▶ All the previous pre-installation sections must be read and
requirements met before starting the appliance or flue installations.
CAUTION
Risk of injury through incorrect lifting and carrying!
▶ Only lift a manageable weight, or ask for help.
▶ Bend the knees and keep the back straight with feet apart, when
lifting or putting down heavy objects.
▶ DO NOT lift and twist at the same time.
▶ Lift and carry object close to the body.
Appliance on site
▶ Check contents of delivery are undamaged.
▶ Remove the appliance from its packaging check the contents against
the scope of delivery.
▶ Once the appliance is unpacked the installation can commence.
Important handling instructions
• It is advised that two people are used to carry the carton from the
vehicle to the point of delivery.
• Once the carton is in the property, the outer carton is removed first.
Care should be taken when releasing the straps. If a sharp implement
is used make sure the outer carton is not pierced and that the
implement is used in such a way so that it may not cause personal
injury.
• All sharp objects must be covered or the blade retracted after use and
put away in a safe place. Care should be taken when lifting the
appliance from the base and the proper technique for safe lifting of
any heavy object should be strictly observed.
The appliance packaging and base tray are designed so that the
appliance can be tilted backwards onto the outer carton. The carton then
becomes a protective mat.
Now remove the front casing and set safely aside. This is to protect the
casing from damage during installation.
Greenstar 2000 – 6 721 820 552 (2021/02)
Removing the front casing
The front casing is secured with two screws which are critical to maintain
the case seal and to prevent unauthorised removal (electrical safety).
▶ Always secure the casing with these screws.
▶ Loosen the two screws [1] and pull the bottom of the casing forward.
▶ Lift off the casing.
Fig. 40 Removing the front casing
Additional requirements for roof space installations
• The unpacked appliance can now be moved into the loft space
• Two sets of steps should be used.
• Two people should share the lifting of the appliance up to the loft
hatch, tilt and slid on its back into the loft space.
• Ensure that the roof space has permanent fixed lighting, a permanent
fixed retractable ladder and a fixed floor area, from the hatch to the
appliance installation point. This will allow access for installation,
normal use and servicing.
Before installing the appliance, ensure that the system has been
cleaned.
Installation
1
35