Ｍ】 Actuator (Transducer) - Kawai ANYTIME X2 GP Service Manual

〔6〕 PARTS LIST & ASSEMBLING INSTRUCTIONS
【M】 Actuator (Transducer)
【M-1】 Assembling the Actuator (Transducer)
Assembling Instruction
1. Attach actuator cushion ④ on actuator ③ .
＊ Observe the attaching position shown in the drawing upper right.
2. Insert one serrated flange hex lock nut ⑥ into hexagon head bolt ⑤ .
3. First insert actuator support ① and plain washer ⑦ on the above mentioned hexagon head bolt, then
insert actuator nut ② on it.
4. Additionaly insert one serrated flange hex lock nut ⑥ .(Pay attention to the direction of nut. See the
drawing below)
5. After that, insert actuator ③ on it, then tighten nut ⑥ firmly.
6. Turn the actuator nut ② for adjusting until its postion becomes as shown in the drawing lower right,
then tighten nut ⑥ firmly.
All manuals and user guides at all-guides.com
– 53 –
Attaching Position of Actuator Cushion
＊ Attach it in the exact same concentric circle with Actuator ③ .
Attaching Position of Actuator
No. Description Description
1 Actuator Support Actuator support
2 Actuator Nut Actuator nut
3 Actuator Actuator
4 ACTUATOR CUSHION Actuator cushion
5 HEXAGON HEAD BOLT Hexagon head bolt
SERRATED FLANGE HEX
6 Serrated flange Hex lock nut
LOCK NUT
7 PLAIN WASHER NORMAL Plain washer Normal
Remarks PN
918318
918334
KSTR-001 815500
5 x 85 815781
M6 x 80 861774
M6 861766
M6 918628