4〕 Check And Adjust Modes; Ａ】 Activating The Check Mode; Ｂ】 Checking Switches And Pedal Sensors - Kawai ANYTIME X2 GP Service Manual

〔4〕 CHECK AND ADJUST MODES
※ This section describes the modes needed for performing checking and adjustments when a problem occurs.
※ Before running these modes, you need to switch to the Silent Mode by pulling the mute lever located
under the keybed (at the treble side).
【A】 Activating the Check Mode
Starting from power-off
Press down and hold the [ ◀ ], [
message below appears on the LCD display, release the buttons.
(＊ : diff ers depending on models and market location.)
※ To exit from the Check Mode, turn the power off .
【B】 Checking Switches and Pedal Sensors
① Press all the buttons in rotation and check if the corresponding button name appears on the LCD display
and "○" at the corresponding position change as follows; ○→●→◦
Also, make sure that the LED light is turning on and off when pressing the buttons except "Value"
▲ ▼
buttons [ ◀ ], [ ], [
※ If nothing appears on the LCD or the LED does not turn on and off when the button is depressed, the
circuit board inside the switch panel may be defective.
［ 1 ］
［ 2 ］
［ REC ］
All manuals and user guides at all-guides.com
▲
] and [ ▶ ] buttons simultaneously, then turn the power on. When the
Left screen turns to right one after a while.
], [ ▶ ]. LED color of REC button is red, and the others are green.
– 14 –