Ｌ】 Speaker - Kawai ANYTIME X2 GP Service Manual

〔6〕 PARTS LIST & ASSEMBLING INSTRUCTIONS
【L】 Speaker
【L-1】 Enclosure
Assembling Instruction
1. Attach speaker ③ on speaker board ② with
four screws ⑩ .
＊ Observe the attaching position shown in
the drawing below.
Speaker Installing Position
・ Install the speaker while keeping its
terminals in the position shown in the
drawing
Speaker Terminal
Detail B 1 : 1
Edge of Speaker Grill
All manuals and user guides at all-guides.com
2. Attach speaker cushion ④ along the inner diameter of
speaker grill edge of enclosure ① .
＊ Refer to Cross section A-A and Detail B.
3. Attach the speaker assy assembled in Step 1 on
enclosure ① with four screws ⑧ .
＊ Attach the speaker terminal at the position shown
in the drawing.
Speaker Terminal
Position where speaker cushion is attached
Speaker Grill
Detail B
4. Attach acoustic material (acoustic absorbing material) ⑤ on enclosure ① .
Insert the bass reflex port into the opening, then fasten it with four filament tapes ⑨ .
＊ Attach the filament tapes at the area shown in the drawing below right.
5. Attach enclosure cushion (3) (4) ⑥ ⑦ on the edge of enclosure ① .
＊ Check the holes positions and align them to the outer border of the enclosure.
Bass reflex port
No. Description
1 ENCLOSURE
2 Speaker Board
3 SPEAKER
4 Speaker Cushion
5 Acoustic Material
6 ENCLOSURE CUSHION (3)
7 ENCLOSURE CUSHION (4)
+ BINDING TAPTITE SCREW
8
P TITE
9 Filament Tape
+ TRUSS SELF TAPPING
10
SCREW TYPE A
– 51 –
Description Remarks
Enclosure
Speaker board
Speaker 12 cm
Speaker cushion 5 x 10.5 x 390
Acoustic material 10 x 150 x 180
Enclosure cushion (3)
Enclosure cushion (4)
+ Binding taptite screw P tite M4 x 20
Filament tape 12 x 80
+ Truss self tapping screw
4 x 10
type A
PN
933970
918351
815474
816618
816619
811364
811365
812257
798810
812257