Table of Contents
Advertisement
Emergency Keys (Fire, Auxiliary Panic)
This feature allows the FAP emergency keys to be
enabled or disabled per station. These keys operate
as part of the DSC security panel interfaced to the
Communiqué through the Security Interface Card.
Note: If the DSC security panel is not interfaced
Note: If the DSC security panel is not interfaced
Note: If the DSC security panel is not interfaced
Note: If the DSC security panel is not interfaced
Note: If the DSC security panel is not interfaced
to the Communiqué, the FAP keys will not function
to the Communiqué, the FAP keys will not function
to the Communiqué, the FAP keys will not function
to the Communiqué, the FAP keys will not function
to the Communiqué, the FAP keys will not function
from any station regardless of how this feature
from any station regardless of how this feature
from any station regardless of how this feature
from any station regardless of how this feature
from any station regardless of how this feature
is programmed.
is programmed.
is programmed.
is programmed.
is programmed.
To access this function, press the [PGM] key three
times. The display may prompt you for the Installer
PIN. If the correct PIN is entered, or if no PIN is
required, the display will read...
Select Installer
Program Item
Press the [SECURITY] key. The key will begin to
flash slowly and the display will read...
Security Keys
Enable/Disable
Press the [SECURITY] key again. DSS keys 10
through 33 will be lit solid and the display will
read...
Select Station
Select the station you wish to program by pressing
the corresponding lit DSS key. For example, if the
DSS 10 key is pressed, the key will start flashing
slowly and the display will read...
Station 10
Prog FAP keys
S
E
C
T
I
27
firealarmresources.com
O
N
1
0
The FAP keys will be either flashing quickly or lit
solid depending on how they were previously
programmed.
• Flashing quickly: The feature is enabled.
• Lit solid: The feature is disabled.
To enable or disable each of the Security keys,
press the desired key and the setting will be
toggled.
When the programming of the keys for a particular
station is finished, press the PGM key to save the
changes.
To select another station to program, press another
DSS key.
The Emergency keys will not function
from any keyset that is in a program-
ming section, including the radio
programming section.
Advertisement
Table of Contents
