Table of Contents
Advertisement
T
E
M
P
See the example in section 8.2, "Thermostat
Occupancy Settings and Modes".
To provide users with a simple method of turning
on any mode, see section 8.3 "Programming Modes
to Follow PGM Outputs".
If you assign an occupancy setting to
more than one mode, the item follows
its assigned schedules/PGM outputs
when any of its assigned modes are
ON. To prevent an item assigned to
more than one mode from following
any of its assigned schedules/PGM
outputs, ALL the modes assigned to
the item must be turned OFF.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Occupancy Setting
Mode Assignment ........... sections [802] - [880]
Follows Schedule/Output
only if Mode On .. sections [800] to [863]: [05]-[08]
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
9.8 Assigning Occupancy
Settings to PGM Outputs
You can assign an occupancy setting to follow a
panel event (e.g. a fire or burglary alarm, or a
[ ][7][1-4] command). To do this, assign the
occupancy setting to a PGM output programmed
to follow the same event.
See your control panel Installation Manual for a list
of available panel events (PGM output options).
Example : if you assign the Auxiliary occupancy
setting to follow a PGM output programmed as
Command Output 1, the VPM5580TC will switch
the thermostat to the Auxiliary setting whenever the
user activates the command output (e.g. using
[ ][7][1]).
E
R
A
T
U
firealarmresources.com
R
E
C
O
Please refer to your control panel's Installation
Manual for a complete description of available
PGM output options.
To assign an occupancy setting to a PGM output:
1. Enter the 3-digit section number corresponding
to the occupancy setting of the thermostat you
want to program [804] - [882].
2. Enter the 2-digit number of the PGM output you
want the item to follow (01-14).
3. If you have assigned occupancy settings to
PGM outputs programmed as a Command
Outputs ([*][7][1-4]), you can program a label
for the Command Output in programming
sections [545] - [548] (Output Control labels).
See section 3.4, "Programming Label Entry
Sections".
Do not program two Occupancy
Settings on the same thermostat to
follow the same PGM output in the
system.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Occupancy Setting
Output Follower ............... sections [804] - [882]
Command Output Labels Sections [545] - [548]
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
26
N
T
R
O
L
Advertisement
Table of Contents
