Motor; Disassembly And Repair, Continued - LG WM3001HRA Training Manual

TRAINING MANUAL

DISASSEMBLY and REPAIR, continued

MOTOR

WM3001H*A
Remove the back cover.
Remove the large bolt in the center shaft.
DO NOT stick a screwdriver or other
object through the slots in the rotor.
Pull the rotor off the shaft.
Remove the ground screws and wire
retainers from the stator wires.
(See photo, below.)
Remove two screws from the tub bracket.
Remove six bolts on the stator. Lift it off
and support it while you unplug two
connectors on the stator.
Set the stator aside.
When re-installing the stator, the clamps
and the ground screw must be installed
and the connectors pressed into place
before the rotor is bolted onto the shaft.
When you replace the rotor, the shaft can
be pressed forward so far the bolt will not
reach it. If you can't hold the tub back
while you install the bolt, get a longer bolt
with the same thread. Place the rotor
onto the shaft, install the long bolt, and
pull the shaft back while you push the
rotor all the way on. Then remove the
long bolt and replace it with the correct
bolt. Tighten to specification.
Page 49
WM3001H*A
Washer