LG WM3001HRA Training Manual page 115

TRAINING MANUAL
9. Rinse Spin
10. Remaining Spin
11. Rinse Water
Supply
12. Rinse
13. Final
Draining
14. Detangling
15. End of Cycle
WM3001H*A
Process Technical Information, continued
* The water remaining in the load is extracted by centrifugal
force while the drum is spun at the selected speed.
* The power to the motor is cut off and the drum continues
to spin by inertia until it stops.
* This process overlaps the next process, rinsing.
* Cold water is supplied to the drum for rinsing the load.
* After the water is supplied, the drum is rotated clockwise
and counterclockwise to rinse the load.
* After the rinse cycle is completed, the power to the motor
is cut off and the drum continues to spin by inertia until
it stops.
* If RINSE HOLD is selected, the drum is not drained after the
rinse cycle is completed.
* At the end of the cycle, the power to the motor is cut off
and the drum continues to spin by inertia until it stops
turning. Then it is rotated slowly, alternately counter-
clockwise and clockwise, several times in each direction to
help untangle the load.
* At the end of the cycle, the display shows END for
8 seconds. The machine reverts to the STANDBY mode,
and the door is unlocked.
Page 114
WM3001H*A
Washer