Canon STAPLER SORTER-L1/MS-C1 Service Manual page 97

3. Adjusting the guide bar swing range
Make these adjusments whenever you have replaced the following parts. (If you have removed
the guide bar, be sure to adjust it in advance so that it is level before making these adjustments.)
• Sorter controller PCB
• Guide bar home position sensor (PI6)
• Guide bar swing motor (M3)
Procedure
1) Prepare a sheet of copy paper of A4 or LTR size.
2) Remove all the paper in the bin unit.
3) Detach the rear cover and set up the dip switch (SW3) on the sorter controller circuit PCB as
shown below. (Care should be taken at this time since the setting varies depending on the size
of the copy paper used.)
(When A4 copy paper is used)
* The No. 6 switch is used for switching the communication method with the copier and should not
be moved.
COPYRIGHT © 1998 CANON INC. CANON STAPLER SOTRER-L1 MS-C1 REV.0 NOV. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
*
ON
1 2 3 4 5 6
Figure 5-102
CHAPTER 5 TROUBLESHOOTING
ON
1 2 3 4 5 6
(When LTR copy paper is used)
*
5-3