Canon STAPLER SORTER-L1/MS-C1 Service Manual page 47

2. Operations in response to over-stack condition
When the number of loaded copies in each mode set for the bins as described above is
exceeded, the copier operates as follows:
a. Non-sort mode
Example of setting
• DF in use
• Small size paper used
• No. of documents: 5
• Set No. of copies: 30
1) Set up as shown for the above example and turn ON
the copy start key.
2) Each time when the document is changed, 30 copies
are delivered to the sorter.
3) When 100st* copy is delivered to the 1st bin, the
operation stops once.
4) By removing the copies in the bin unit and turning
ON the copy start key again, copying is performed
for remaining sheets (50 sheets*) of paper and
delivered to the bins.
* Capacity per bin may vary depending on restrictions on the host copier.
b. Sort mode/Group mode/Stack mode
Depend on the copier specifications.
COPYRIGHT © 1998 CANON INC. CANON STAPLER SOTRER-L1 MS-C1 REV.0 NOV. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 2 OPERATIONS AND TIMING
2-23