Canon STAPLER SORTER-L1/MS-C1 Service Manual page 103

3. Adjusting the guide bar parallelism (Stapler sorter only)
After the bin unit is disassembled or the set screw on the guide bar is removed, the guide bar
parallelism should be adjusted.
1) Adjusting method
Set a sheet of B5 or A4R size paper respectively in the first and 10 bins.
Push the guide bar [1] by hand toward the paper until it touches the paper.
Check the paper in the first and 10 bins for the touch condition with the guide bar. If the paper
and the guide bar are not in parallel, remove the screw [3] of the guide bar holder [2] and adjust so
that they are in parallel.
[1]
COPYRIGHT © 1998 CANON INC. CANON STAPLER SOTRER-L1 MS-C1 REV.0 NOV. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
[2] [3]
Figure 5-112
CHAPTER 5 TROUBLESHOOTING
5-9