Canon STAPLER SORTER-L1/MS-C1 Service Manual page 114

CHAPTER 5 TROUBLESHOOTING
Object
A3 Size Feeding
Speed Switching
Mode
* The No.6 switch is used for switching the communication method with the copier and should not be
moved.
(ON: level 2 (New) IPC communication/OFF: Level 1 (Former) IPC Communication)
2) Non-staple sorter
Functions of the dip switch (SW3) on the sorter controller PCB are shown in the table below.
Object
Normal copy
condition
Feed mortor (M2)
Aging Mode
* The No.6 switch is used for switching the communication method with the copier and should not be
moved.
(ON: level 2 (New) IPC communication/OFF: Level 1 (Former) IPC Communication)
5-20
COPYRIGHT © 1998 CANON INC. CANON STAPLER SOTRER-L1 MS-C1 REV.0 NOV. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
Setting
*
ON
1 2 3 4 5 6
Setting
*
ON
1 2 3 4 5 6
*
ON
1 2 3 4 5 6
*
ON
1 2 3 4 5 6
Function
Each press on the Manual Staple key will turn
on and off the Manual Staple LED, allowing
you to switch the feeding speed as follows
with reference to the LED.
Normally, A3 paper is fed at 510 mm/sec; if
stacking is not proper because of downward
curling in staple sort mode, change the
feeding speed to 350 mm/sec.
Manual Staple LED ON:
feeding speed of 350 mm/sec
manual Staple LED OFF:
feeding speed of 510 mm/sec
When you have changed the settings, turn off
the copier, and shift the DIP switch to its
original settings.
Function
By turning OFF all the swiches, mormal copy
condition is set up.
When the Manual Shift Up button (SW1) or
the Shift Down switch (SW2) is pressed, the
feeder motor (M2) starts to rotate clockwise
(paper feeding direction).
To stop, press the Manual Shift Up button
(SW1) or the Shift Down switch (SW2).
When he Manual Shift Up button (SW1) or
the Shift Down switch (SW2) is pressed,
aging starts.
1. Executes initialization operations; e.g., bin
position.
2. Makes 10 copies of a single original in sort
mode (delivering a single sheet into bins 1
through 10).
3. Selects bin 1.
4. Repeats operations 1 through 3.
When the Manual Shift Up button (SW1)
or the Shift Down switch (SW2) is pressed
once again, aging operation starts.