Omron LD-60 User Manual page 69

5. If the box is to be used as a door box, connect wires from Digital Output 1 on the back
of the box to the door actuator.
This output will have to be configured in the MobilePlanner software. See Adding Door
Areas to Your Map on page 74 and Figure 5-4
Both call buttons and door boxes have two external inputs and two external outputs.
The I/O for door boxes can be configured in the MobilePlanner software. The behavior of
the I/O for call buttons is hard-coded. See External I/O on page 55.
6. Attach the box to the wall mount, using four supplied self-tapping screws. See the fol-
lowing figure.
Figure 5-20 Attaching the Call/Door Box to its Mount, Two Wall Mounts Shown
7. Reattach the two screw covers to the box.
Press down on each cover, and slide it toward the center of the box. It will snap into
place.
13732-000 Rev J
Figure 5-21 Assembled Call/Door Box
LD Platform Peripherals Guide
Chapter 5: Call/Door Boxes
69