Checklists Prior To Mounting - Siemens SIMOTICS S-1FK2 Operating Instructions Manual

5.2

Checklists prior to mounting

Note
Required checks
The checklists below do not purport to be complete. It may be necessary to perform additional
checks and tests in accordance with the situation specific to the particular installation site.
• Install the motor as described in the following chapters of the operating instructions.
• Thoroughly familiarize yourself with the safety instructions and observe the checklists below
before starting any work.
Table 5-1
General checks
Are all necessary components of the configured drive available?
Are the ambient conditions in the permissible range?
•
Table 5-2
Check of the mechanical system
Is the motor free of visible damage?
Have the mounting surfaces (e.g. flange, shaft) on the customer machine and on the
motor been cleaned?
Are the mounting surfaces free of corrosion?
Do the mounting dimensions (e.g. shaft diameter, shaft length, true run) on the customer
machine meet the specification?
SIMOTICS S-1FK2 synchronous motors for SINAMICS S120
Operating Instructions, 02/2022, A5E46089564B AD
Checklist before installing
Section "Ambient conditions (Page 24)"
Checklist for checking the mechanical system
Check
Check
Mounting
5.2 Checklists prior to mounting
OK
OK
59