© 2021 Avaya Inc. All rights reserved
Configure the CU360 for USB Audio/Video Bar Mode
USB Audio/Video Bar Mode can be activated manually on CU360, once a connected computer is
detected. The CU360 can also be configured to keep USB Bar mode always active.
[G
UI
[W
•
Release Notes for Avaya Collaboration Unit CU360
•
If your laptop is not detected, assure that you are using a USB 3.0 cable
connected to CU360's type-C port.If you need a cable longer than 2.7 m (8.8
ft), use an active USB booster extension cable. Don't use a cable suitable only for
charging devices.
USB peripherals into the CU360 if you plan to use the CU360 itself as USB Camera.
•
If you want to extend the computer configuration to include an external monitor
with this setup, connect your computer to the monitor in your usual way.
Important
•
If you plan to use the CU360 only in USB A/V Bar Mode, without connecting any
monitor to it, it is strongly suggested to configure the CU360 Bar Mode as
"Always Active".To change CU360 USB Bar Mode configuration, go to
] C
> C
>
ONFIGURE
USTOMIZATION
] [A
L
] A
EB
DMIN
OGIN
DMINISTRATOR
USB Bar Mode: Manual*/Always active.
o
Manual: once the computer connected to the CU360 via USB is detected, you
can activate USB Bar mode via the remote-control or the web interface.
o
Always Active: just connect your computer to the CU360 via USB to start
using the CU360's audio/video peripherals from your computer. No further
manual interaction or activation is required.
Important
•
While the USB Bar Mode is active (for manual activation or persistent "always
active" configuration) all the other functionalities of the device are disabled.
o
Incoming call will be automatically rejected (Do not disturb mode) and
calendar meeting notifications are silenced.
o
From the GUI and the Web interface you can only turn-off USB A/V Bar
Mode.
It is strongly suggested to not plug an USB extra camera or other
S
> S
> C
ETTINGS
YSTEM
USTOMIZATION
>
What's New 33