Configuring Connection Event For Cerberus Mobile - Siemens FS720 Configuration

13.12 Configuring connection event for Cerberus Mobile

Building Technologies
Fire Safety
A station can be configured so that it issues an event when a mobile device
establishes a connection to the station via the 'Cerberus Mobile' application. All
stations that have corresponding visibility of the station then display a
corresponding message on the display of the Person Machine Interface. At the
same time, the station records the event in the event memory.
Configuration process
w You have already configured the 'Cerberus Mobile' application for a station.
You will find information on this in chapter 'Configuring visibility for Cerberus
Mobile [➙ 282]'.
w You have already registered at least one mobile device on the 'PMI' of the
station. You will find information on this in document 'A6V10418718'. See
chapter 'Applicable documents'
1. Highlight the following element in the 'Operation' task card under the station on
which you have registered the mobile device: 'Cerberus Mobile' > 'Cerberus
Mobile client'
Information: Each 'Cerberus Mobile client' element represents a mobile device
enabled at the station.
2. Select the 'Events' tab in the detail editor.
3. Open the 'Cerberus Mobile connected' event in the tab.
4. Put a check mark next to the 'Enabled' property or remove it, depending on
whether the station should issue the event or not.
5. Repeat the previous configuration steps for all mobile devices for which you
want to configure this behavior.
6. Save the configuration.
See also
2 Configuring visibility for Cerberus Mobile [➙ 282]
Configuring connection event for Cerberus Mobile
'Operation' task card
13
311 | 412
A6V10210424_j_en_--
2018-08-29