Installing The Transmission Support - Toro TITAN MAX Operator's Manual

4. Align the holes on the support to the bolts on the
drive assembly and loosely install the nuts that
you set aside (Figure
Figure 20
1. Flange nut (5/16 inch)
2. Washer
3. Bolt (5/16 x 3-1/4 inches)
5. Use the 2 bolts (5/16 x 3-1/4 inches) and nuts to
secure the support to the frame
Note:
The support mounting tab is installed on
the inside of the frame; it does not cover the
decal.
20).
4. Left bagger support
5. Drive-assembly bolt
6. Flange nut (5/16 inch)
(Figure 20).
6. Tighten all the hardware that you installed.
7. Follow this procedure to install the right support
frame.
9
Installing the Transmission
Support
Parts needed for this procedure:
1 Transmission support
Procedure
1. Remove the 2 flange nuts from the support bolts
on the left and right transmissions and set them
aside (Figure
1. Support bolt
2. Flange nut
g037894
2. Align the bracket to the support bolts and secure
them with the 2 flange nuts you removed in the
previous step
16
21).
Figure 21
3. Transmission support
(Figure 21).
g037895