Installing The Baffle And Blower Support - Toro E-Z Vac 79346 Operator's Manual

Note:
Your chute may look different than the
one pictured.
Figure 6
1. Rod
2. Cotter pin (CE models
only)
3. Deflector
2. Remove the deflector
3. Remove the 4 screws (1/4 x 1/2 inch) securing
the right belt cover, and remove the belt cover
(Figure 7).
Note:
Retain the 4 screws (1/4 x 1/2 inch) for
installation in Procedure
Assembly, Belt Cover, and Shoulder Bolt (page
10).
Figure 7
1. Screw (1/4 x 1/2 inch)
g190642
4. Spring
5. Deck brackets
6. Spring installed over the
rod
(Figure 6).
5 Installing the Pulley
g200974
2. Belt cover
4
Installing the Baffle and
Blower Support
Parts needed for this procedure:
1 Blower support
2 Hex washer-head screw (3/8 x 3/4 inch)
1
Baffle
4 Carriage bolt (5/16 x 3/4 inch)
4 Flange nut (5/16 inch)
Procedure
1. Install the blower support to the mower deck
using 2 hex washer-head screws (3/8 x 3/4 inch)
as shown in Figure
1. Hex washer-head screw
(3/8 x 3/4 inch)
8
8.
Figure 8
2. Blower support
g201299