Toro TITAN MAX Operator's Manual page 22

1. Upper tube
2. Rubber seal protruding out
10. Align the upper tube holes to match the dimples
on the surface of the lower tube.
Note:
Ensure that the side profile appears as
shown in Figure
Note:
Do not use the open hole near the
molded arrowheads.
1. Upper tube
2. Existing hole (bolt
removed)
11. Using the existing holes in the upper tube as
a template, drill 2 holes, 6.5 mm (1/4 inch)
diameter, through the dimples on the lower tube
(Figure 33).
Figure 31
3. Bagger hood
32.
Figure 32
3. Notch at the bottom of the
tube when installed
4. Lower tube
g018440
Drilling Lower Discharge Tube
1. Dimples
2. Lower tube
g020776
3. Drill 6.5 mm (1/4 inch)
diameter hole
12. Remove the upper and lower tubes from the
machine.
13. Slide the tubes together and align the holes.
14. Install the washers (1/4 inch) onto the bolts
(Figure 33).
15. Using a hex key tool, install the screws (1/4 x
3/4 inch) and washers (1/4 inch) from the inside
of the lower tube and through the existing holes
in the upper tube
22
Figure 33
4. Upper tube
5. Install screw (1/4 x 3/4
inch), washer (1/4 inch),
and locknut (1/4 inch)
here.
6. Upper tube—existing
holes
(Figure 33).
g018439