Appendix: Regulatory Compliance; Fcc Compliance; Isedc Compliance - Baicells Neutrino430 Installation Manual

Appendix: Regulatory Compliance

FCC Compliance

This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. Any Changes or
modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case the user will be required to
correct the interference at his own expense.
WARNING: This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with a
minimum distance of 20 inches (50 cm) between the radiator and your body.

ISEDC Compliance

This device complies with Innovation, Science, and Economic Development Canada license-
exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause interference,
and (2) This device must accept any interference, including interference that may cause undesired
operation of the device.
The antenna(s) used for this transmitter must be installed to provide a separation distance of at
least 20 inches (50 cm) from all persons and must not be collocated or operating in conjunction
with any other antenna or transmitter, End-Users must be provided with transmitter operation
conditions for satisfying RF exposure compliance.
33