Upgrade Firmware; Figure 3-11: Home Page - Baicells Neutrino430 Installation Manual

Indoor 4x250mw two-carrier tdd enodeb

Hide thumbs Also See for Neutrino430:

Table of Contents

Optionally, you may want to:

1. Change the login password.

2. Confirm the firmware version is the latest available from Baicells; upgrade if needed.

Firmware upgrades can be found at Baicells.com > Support > Firmware. See

for detailed instructions regarding firmware upgrades.

3. Set the Network Timing Protocol (NTP).

For help, refer to the

CloudCore Configuration & Network Administration

3.5.2 Upgrade Firmware

To ensure you are using the most recent software version before configuring the eNB, follow the

steps below.

3.5.2.1 Upgrade Firmware from eNB GUI

1. Download the most recent firmware file from Baicells.com > Support > Firmware, and save

on local computer.

2. Go to System > Upgrade, and select whether to preserve the current settings.

3. Select Choose File, and navigate to the firmware file saved on local computer.

NOTE: The file type is *.IMG

4. Click Upgrade.

5. In the pop-up window click PROCEED.

6. The base station reboots after approximately three minutes.

7. On the Basic Setting > Basic Info page, the upgraded version is displayed in Software

Version.

Section 3.5.2

Guide.

Table of Contents