Table of Contents
Advertisement
Table 3-1: WAN/LAN/VLAN
Field Name
Allow Management
Access Over WAN
Connect Type
MTU
DNS Address 1
DNS Address 2
WAN Config
IP Access Mode
Current IP
Option60
Subnet Mask
Prefix
Gateway
VLAN ID
3.5.4.2 LGW
The Local GateWay (LGW) setting must be configured when using the Baicells CloudCore Evolved
Packet Core (EPC). Refer to Figure 3-14 and Table 3-2. You must reboot the eNB when you make
changes to these settings.
Figure 3-14: LGW
Description
Enable or disable the Local Maintenance Terminal connection through the
WAN port.
Used to select the type of connection for the eNB (Copper or Fiber)
Used to specify the maximum size of the network layer protocol data unit that
can be communicated in a single network transaction. Range is 700–1600.
Used to define the DNS 1 IP address
Used to define the DNS 2 IP address
Used to enable the interface. Four IP addresses are the maximum number the
eNB supports.
Used to select the desired interface protocol: DHCP, Static IP, IPv6 DHCP, or
IPv6 Static IP
The WAN interface IP address
Used to differentiate between different terminals when IP Access Mode is set
to DHCP
Used to define subnet mask address if IP Access Mode is set to Static IP
Prefix of IPv6 address for WAN interface if IP Access Mode is set to IPv6 Static
IP
Used to define gateway address if IP Access Mode is set to Static IP
Used to configure more IP addresses for the WAN interface through the VLAN
when there is a need to transmit multi-types of data.
23
Advertisement
Table of Contents
