Configure Carrier Setting; Reboot; Figure 3-19: Carrier Setting - Baicells Neutrino430 Installation Manual

Indoor 4x250mw two-carrier tdd enodeb

Hide thumbs Also See for Neutrino430:

Table of Contents

3.5.7 Configure Carrier Setting

Reference:

Carrier Aggregation & Dual Carrier (Split Mode) Configuration Guide

The Carrier Setting menu is used only in the two-carrier Neutrino430 eNB (Figure 3-19). You can

set the eNB to run as a single carrier, as two combined carriers using Carrier Aggregation (CA), or

as two independent carriers using Dual Carrier (DC)/split mode, depending on which licenses you

have purchased. Single carrier (no CA) means only Cell 1 will operate and use only two Radio

Frequency (RF) ports instead of four. Operators may need to use this mode if they have limited

spectrum or are planning to change to CA or DC mode at a later time when more capacity is needed

for the coverage area. Go to BTS Setting > Carrier Setting to configure Carrier Mode. Click the arrow

to view the drop-down menu.

Whenever you change the carrier setting, you must reboot the eNB for the change to take effect.

Once the basic configuration settings are saved, reboot the eNB. There are two options for

rebooting in the eNB GUI. From the landing page of the eNB GUI, navigate to System > Reboot, or

select Reboot under the Welcome banner (Figure 3-20).

Table of Contents