Table of Contents
Advertisement
Setup
SSID
Options
Mode
Channel No.
Broadcast
SSID
Wireless Security
Current Setting
Configure
Button
Access Point
Enable Wire-
less
Access Point
This is also called the "Network Name".
•
If using an ESS (Extended Service Set, with multiple access
points) this ID is called an ESSID (Extended Service Set
Identifier).
•
To communicate, all Wireless stations should use the same
SSID/ESSID.
Select the desired mode:
•
802.11G-plus (TI) This allows clients to use any of the
following modes:
•
Standard 802.11b
•
802.11B+ (Texas Instruments proprietary enhanced mode)
•
Standard 802.11g
•
802.11G-plus (Texas Instruments proprietary enhanced
mode). This mode can increase throughput by up to 50%,
but will only work between compatible TI wireless stations.
•
802.11g & 802.11b - Both 802.11.g and 802.11b Wireless
stations will be able to use the ADW-4302v2.
•
802.11g only - Only 802.11g Wireless stations can use the
ADW-4302v2.
•
802.11b only - Only 802.11b connections are available.
802.11g Wireless Stations will only be able to use the ADW-
4302v2 if they are fully backward-compatible with the
802.11b standard.
Select the Channel you wish to use on your Wireless LAN.
•
If you experience interference (shown by lost connections
and/or slow data transfers) you may need to experiment with
different channels to see which is the best.
•
If using multiple Access Points, adjacent Access Points
should use different Channels to reduce interference.
If enabled, the ADW-4302v2 will broadcast its SSID. This allows
PCs and other wireless stations to detect this Access Point and
use the correct SSID.
If disabled, PC users will have to manually enter the SSID and
other details of the wireless interface before they can connect to
this Access Point.
The current Wireless security is displayed. The default value is
Disabled.
Click this button to access the Wireless security sub-screen, and
view or change the settings. See the following section for details.
Enable this if you want to use Wireless Access Point function.
If disabled, no Wireless stations can use the Access Point
function, and all connections must be made via the wired LAN.
17
Advertisement
Table of Contents
