Ferrari 612 Scaglietti Owner's Manual page 44

Increasing the stored speed
This can be done in two ways:
- pressing the accelerator pedal and then storing the new speed
reached;
or
2
- turning the end knob B upwards (+).
Each turn of the end knob corresponds to an increase in speed of
about 2 km/h, while holding the end knob turned upwards means a
continuos variation of the speed.
Decreasing the stored speed
This can be done in two ways:
- deactivating the device and then storing the new speed;
or
- turning end knob B downwards (-) until reaching the new speed,
which will automatically be stored.
Each turn of the end knob corresponds to a decrease in speed of about
2 km/h, while holding the end knob turned downwards means a
continuous variation of the speed.
C A
B
44
Deactivating the device
Turn the end knob A to OFF or turn the ignition key to 0. The device is
also deactivated automatically in the following conditions:
- when the brake or clutch pedal is pressed.
While driving with the device on, do not place the
gearshift lever on idle.
In the event of malfunctioning or failure of the device,
turn the end knob A to OFF and contact the F
S N .
ERVICE ETWORK
ERRARI