Rear View - Panasonic WJ-HD100 Operating Instructions Manual

!7 REW/FF and Up Button [REW/FF 1/2] [D]
Press this button to rewind or fast-forward the recorded
field. The LED lights in the REW/FF mode.
Press this button to move the cursor upward in a setup
menu on the monitor.

Rear View

@1 @3 @4
IN
IN
OUT
OUT
CAMERA
AUDIO
SW OUT
@2
@1 Audio Input [AUDIO IN]
RCA standard jack accepts an unbalanced –10 dB and
10 k line input audio signal supplied from an external
device.
@2 Audio Output [AUDIO OUT]
RCA standard jack supplies an unbalanced –10 dB and
600 line output audio signal to an external device.
@3 Camera Switching Output [CAMERA SW OUT]
This jack is for connecting an external device such as a
video multiplexer receiving multiple camera inputs. The
switching signal supplied makes the connected device
switch from one camera to the other. Use this terminal
only when the recording field rate is lower than 10 fps.
@4 Video Input [VIDEO IN]
This BNC accepts a video signal supplied from a cam-
era or video multiplexer. A 75
unless the video output terminal is connected.
@5 Video Output Connector [VIDEO OUT]
This BNC supplies a video signal looped through the
video input terminal. Connect with a video monitor to
check the input picture, or the next WJ-HD100 in a
SERIES connection.
7
@6 @7 @8 @9
MONITOR OUT
VIDEO RS-232C DATA MODE
(PLAY)
@5
termination is made
!8 JogDial [PUSH –
Press the JogDial to pause or restart playback.
Rotate the JogDial to access the desired field while
rewinding, fast-forward and playing back.
Rotate the JogDial to search the oldest picture record-
ed on the disk for playing back in chronological order.
Rotate the JogDial to select a parameter in a setup
menu.
Press the JogDial to enter the selected parameter and
move the cursor to the next position on a setup menu.
Hold down the JogDial to copy still pictures to the
CompactFlash card.
TIME SERIES
REMOTE ALARM
ADJUST RECORD
#0 #1 #2 #3 #4
@6 Monitor Output [MONITOR OUT (PLAY)]
This BNC supplies playback pictures stored on the
hard disk, or setup windows. Connect with a video
monitor.
@7 RS-232C Port [RS-232C]
Through this 9-pin D-Sub connector the digital disk
recorder communicates with the personal computer.
Use a reverse type cable for connection with the per-
sonal computer. Protocol and commands are described
in APPENDIX.
@8 Data Port [DATA]
Connect with equipment in the PS
tem controller.
@9 Mode Switch [MODE]
Use this switch for setting unit addresses and initializing
all disk contents and setup data.
Terminal Board
#0 0 Remote In Terminal
These are connected with switches for external control
of major operations on the front panel such as JOG-
CLICK, JOG-LEFT, JOG-RIGHT, ALARM SEARCH,
STEP, REW/FF, STOP/SETUP, PLAY and REC.
#1 1 Time Adjust Terminal
IN and OUT terminals for synchronizing the internal
clock with connected external devices.
PAUSE] [SET]
#5 #6 #7
POWER
ON
SIGNAL GND
OFF
#8
Data chain or a sys-
•