Rear Panel - Panasonic AK-HCU200P Operating Instructions Manual

Parts and their functions
(Continued)

Rear panel


 
> HD/SD SDI OUT connectors
[1], [2], [3/PM], and [4/PM]
These connectors (BNC) are for outputting SDI signals in HDTV and
SDTV formats.
The HD/SD output mode can be selected by setting a menu item.
The output mode can be switched between the [1] and [2]
combination and between the [3/PM] and [4/PM] combination.
SDI output from [3/PM] and [4/PM] can be switched to main line
image output or picture monitor output by setting a menu item or by
ROP control.
 Refer to "SETTING1 Screen" of <Operations and Settings> (pages
11 and 27).
? RETURN IN connectors
[HD/SD SDI 1] and [HD/SD SDI 2]
These connectors (BNC) are for inputting SDI signals for return
images in HDTV and SDTV formats.
The HD/SD input mode can be selected by setting a menu item.
 Refer to "SETTING1 Screen" of <Operations and Settings> (pages
11 and 27).
[VBS]
This connector (BNC) is for inputting analog composite signals for
return images in SDTV format.
 PROMPT connector [IN]
This connector (BNC) is for inputting SD analog composite signals for
the prompter.
A VBS connector [OUT/PM]
This connector (BNC) is for outputting analog composite signals in
SDTV format.
Output can be switched to main line image output or picture monitor
output by setting a menu item.
 Refer to "SETTING1 Screen" of <Operations and Settings> (pages
11 and 27).
B REF connectors
These connectors (BNC) are for inputting reference signals.
Black burst (BB) signals and tri-level sync signals can be input, and
the type of signals input is recognized automatically.
When no cable is connected to the loop-through output connector,
the connector is automatically terminated at 75 Ω. Connecting a cable
to this connector releases 75 Ω termination.
When a cable is connected to the loop-through output connector, be
sure to connect the other end of the cable to a connector.
Reference signal input
Loop-through output
14
 
    
 MIC OUT 1 connector and MIC OUT 2 connector
These connectors are for outputting the analog signals of
microphones 1 and 2 of the camera.
The microphone level is 0 dBm/600 Ω.
<Notes>
z When connecting the MIC OUT 1 and MIC OUT 2 connectors (XLR
z Some commercially available adapter connectors and adapter
 CAMERA connector
This connector is for connecting the optical fiber multi cable (sold
separately).
E ROP connector
This connector is for connecting a ROP (sold separately).
 MSU connector
This connector is for connecting an MSU (sold separately).
This connector is for future function expansion.
It is not currently supported.
 COMMUNICATION connector
This connector is for connecting the intercom signals and tally signals
to the external system.
H LAN connector
This LAN connector (RJ45) is for connecting a computer when
configuring the Web settings.
Use a 10Base-T or 100Base-TX crossover cable to connect the
computer.
 
  
terminals) to the unbalanced input terminals of an external device,
connect them as shown in the diagram below.
XLR terminal
(unbalanced input terminal)
2
1
3
1: Ground (shield) z Make pin 3 open.
z
2: Hot (+Ve)
3: Cold (–Ve)
cables have pin 3 shorted to pin 1.
Using such an adapter connector or adapter cable will cause a
failure.
DO NOT USE
2
1
3
z Do not use an adapter connector or adapter cable
z
that has pin 3 shorted to pin 1.
PIN terminal