Copy To Compactflash Card - Panasonic WJ-HD100 Operating Instructions Manual

Resetting Alarm
The activated alarm is reset by any of the inputs below.
• The preset time has elapsed.
• The [ STOP] button on the front panel is pressed.
• The alarm reset signal is supplied from the connected
device.
Resetting changes the status of the recorder as follows:
• The recorder stops alarm recording.
• The buzzer, if activated, stops beeping.
• The recorder outputs an alarm recovery signal from the
rear panel.
• The Alarm Out signal on the rear panel is reset.
39

Copy to CompactFlash Card

The pictures recorded on the hard disk can be copied to a
CompactFlash card for browsing on a personal computer.
The picture quality depends on the card capacity and the
quality in which the pictures were recorded.
The following card brand proved to be suitable in tests car-
ried out at Panasonic:
Manufacturer Capacity (in MB)
SanDisk 32, 48, 64, 96, 128, 160, 192
1-1
Open the lid.
1-2
5
SETU/ESC
DISPLAY SELECT
STOP
ALARM SEARCH
LCD CONTRAST
4
1. Insert a CompactFlash card.
1-1 Open the card lid.
1-2 Place a CompactFlash card into the slot.
The card must be formatted for Windows 95 or
Windows 98. Do not reverse the card when insert-
ing.
1-3 Make certain to push the lever to the right after
inserting the card.
2. Display the desired picture on the monitor.
Refer to Skip Playback and Step Playback on page 35
for search operations.
3. Press the JogDial to freeze the image just a few fields
prior to where you wish to start copying.
4. Press the LCD button downward to display [Copy To
Card].
1-3
Push the lever to the
right after inserting
the card.
2 3, 6
PUSH– PAUSE SET
/
PLAY REC /
PLAY MODE SELECT
STEP REW/FF
/ /
Digital Disk Recorder WJ-HD
DISPLAY SELECT
LCD CONTRAST