Rear View - Panasonic WJ-NX400K/G Important Information Manual

Major operating controls and their functions

Rear view

➀ ➁
➂
➃
➄
⑥
⑦
① Alarm/Control connector [ALARM/CONTROL]
This connector is used when connecting with an external
device such as a sensor or anti-theft door switch that out-
put alarm signals, or when connecting an alarm device
such as a buzzer or a lamp to the external equipment.
The two provided terminal plug (12 pin) can be mounted.
② Alarm In connector [ALARM IN]
It is used when connecting with an external device such as
a sensor or anti-theft door switch that output alarm signals.
The two provided terminal block plugs (16) can be mounted.
③ Security wire hole
Mount the lock device for the anti-theft security wire.
④ Cable clamp fixing hole (for fixing terminal block
cable)
This is a fitting hole for the (provided) clam to tie and fix the
terminal block cables. Refer to ☞ page 19 for fitting.
⑤ Copy port (USB3.0) [COPY]
Connect an external storage device (external Hard disk
drive, USB memory) to this port and copy images and
audio recorded on the hard disk drive. An external
storage device can also be connected to the copy port
on the front. Use either of them.
* Mouse connection is also available.
⑥ Mouse connection port (USB2.0) [MOUSE]
The provided mouse is connected to this port. The
mouse can be connected to the mouse connection
ports on the front. Use either of them.
⑦ Network port (PC port) [PC]
Connect the recorder with a PC via a network compati-
ble with 10BASE-T, 100BASE-TX or 1000BASE-T. Use
this port when the cameras and the PC are connected
to different network.
⑧ ⑨ ⑩ ⑪ ⑫
(continued)
⑬ ⑭
⑧ Network port (Camera/PC port) [CAMERA/PC]
Connect the recorder with a PC and cameras via a
network compatible with 10BASE-T, 100BASE-TX or
1000BASE-T. When the port is being accessed, the
access indicator (green) blinks. When the port is being
linked, the link indicator (orange) lights.
PC
LAN (10/100/1000 BASE-T)
Access indicator
⑨ Audio output connector (RCA pin jack)
[AUDIO OUT]
Connect such device as a powered speaker. Same
audio output to the main monitor will be output from this
connector.
⑩ Video output connector (BNC) [VIDEO OUT]
Connect a sub monitor (BNC) to this connector. Same
images output from the sub monitor output connector
(HDMI) will be output from this connector.
The default is NTSC output. The setup menu will not be
displayed.
⑪ Main monitor output connector (HDMI)
[A/V OUT MAIN]
This connector is used to connect to an HDMI-ready
monitor (the main monitor). It displays live images,
recorded images, or the setup menu of the recorder.
⑫ Sub monitor output connecter (HDMI)
[VIDEO OUT SUB]
This connector is used to connect to an HDMI-ready
monitor (sub monitor). Only the live images will be dis-
played.
18
⑰
⑮
⑯
Camera/PC
Link indicator