Panasonic WJ-HD100 Operating Instructions Manual page 26

REC MODE
REC RATE
REC QUALITY
DISK END MODE
DISK END BUZZER ON
JOG/EXT REC
REC MODE
1. Move the cursor to DISK END MODE with the up [ ] or
down [ ] button.
2. Rotate the JogDial to select the desired parameter. The
default is STOP.
[STOP]: Stops recording until a mode other than
[STOP] is selected.
[CONTINUE]: Old data is automatically overwritten from
the disk start.
[ALM CONTINUE]: Recording is suspended until an
alarm occurs.
recording overwrites old data from the disk start.
[SERIES]: In series connection, new data is recorded
from start to end of the next recorder's disk and so
forth. In loop connection, new data continuously
overwrites old data.
Disk End Buzzer Setup
205 DISK END BUZZER
The buzzer can be set up to beep at the point where the
disk is full (remaining space 0 %).
REC MODE
REC RATE
REC QUALITY
DISK END MODE
DISK END BUZZER
JOG/ EXT REC
REC MODE
1. Move the cursor to DISK END BUZZER with the up [ ]
or down [ ] button.
2. Rotate the JogDial to select the desired parameter. The
default is ON.
26
REC SETUP
SF- 12H
15FPS
10(1-10)
STOP
JOG CLICK
SF- 12H
DISPLAY SELECT
LCD CONTRAST
When an alarm occurs, alarm
REC SETUP
SF- 12H
15FPS
10(1-10)
STOP
ON
JOG CLICK
SF- 12H
[ON]: Enables the buzzer beep at the disk end (remain-
ing space 0 %).
[OFF]: Disables the buzzer beep.
Jog Click Terminal Definition
206 JOG/EXT REC
The JOG CLICK terminal on the rear panel is connected
with an external switch. The switch is used either to remote-
ly click the JogDial or to implement the preset mode for
manual recording.
JOG/EXT REC
EXT REC MODE SF-
1. Move the cursor to the desired item with the [ ] or [ ]
button.
2. Select the appropriate parameter by rotating the
JogDial.
JOG CLICK: Turning on the external switch has the
same effect as pressing the JogDial.
EXT REC: While the switch is turned on, the preset EXT
REC mode is implemented.
External Recording Mode
207 EXT REC MODE
Select the mode for manual recording after having set the
JOG/EXT parameter to EXT REC.
JOG/EXT REC
EXT REC MODE
1. Move the cursor to EXT REC MODE with the [ ] or [ ]
button.
2. Select the desired mode with the JogDial. Refer to page
24 for the recording mode parameters. The default
value is SF-12H.
JOG CLICK
12H
DISPLAY SELECT
LCD CONTRAST
EXT REC
SF- 12H
DISPLAY SELECT
LCD CONTRAST