Series Connection - Panasonic WJ-HD100 Operating Instructions Manual

Series Connection

The diagram below shows an example where multiple disk recorders are connected in series or loop for long time recording,
and a video multiplexer is used.
Camera
POWER
ON
OFF
REC Out
Video In
1st Recorder
IN
IN
OUT
OUT
CAMERA
MONITOR OUT
AUDIO VIDEO
SW OUT
(PLAY)
Monitor
Out
Video Out
2nd Recorder
Recorder
(up to 16th)
IN
IN
OUT
OUT
CAMERA
MONITOR OUT
AUDIO VIDEO
SW OUT
(PLAY)
Recommended video multiplexers are Panasonic's WJ-FS series or similar models having specifications as follows.
• Switching recognition signal is located within 8H prior to the end of vertical blanking.
• A camera switching rate of 4/60 seconds or more is available.
See SERIES RECORDING in APPENDIX for setup and operating procedures.
12
Monitor Out
Video Multiplexer
Playback In
RS-232C DATA MODE
REMOTE
RS-232C DATA MODE REMOTE
Video In
Note:
Set the field rate to7.5 fps or
slower when connecting the
Camera SW Out signal with
the video multiplexer.
SERIES
ALARM
TIME SERIES
ALARM
ADJUST RECORD
RECORD
SERIES
ALARM
RECORD
TIME SERIES ALARM
ADJUST RECORD
SERIES
ALARM
RECORD
Video Monitor
POWER
ON
OFF
ON
SIGNAL GND
OFF
ON
SIGNAL GND
OFF
Connect only when configuring
a loop recording.