Table of Contents
Advertisement
Periodic maintenance and adjustment
only the recommended oil. (See page
78.) Make sure that no foreign material
enters the engine oil tank.
7.
Check the O-ring for damage, and re-
place it if necessary.
8.
Insert the dipstick into the oil filler hole,
and then tighten the oil filler cap.
9.
Connect the oil level gauge coupler.
10. Install the right side cover (PZ5NX), or in-
stall the right side cover and the right up-
per cover, and then close the shroud
(PZ5NT).
To change the engine oil
1.
Place the snowmobile on a level surface
and apply the parking brake.
2.
Start the engine, warm it up for several
minutes, and then turn it off.
3.
Remove the right side cover (PZ5NX), or
open the shroud and remove the right
upper cover and the right side cover
(PZ5NT). (See page 44 for the proce-
dures.)
4.
Remove the bottom panel by removing
the bolts.
2
1. Bottom panel
2. Bolt
5.
Remove the right lower cover by remov-
ing the bolts.
54
[ECS00463]
1. Right lower cover
2. Bolt
6.
7.
1. Oil level gauge coupler
2. Oil filler cap
8.
1. Engine oil drain bolt (oil tank)
2. Gasket
2
Place an oil pan under the oil tank to col-
lect the used oil.
Disconnect the oil level gauge coupler.
Remove the oil filler cap, and then re-
move the engine oil drain bolt and its
gasket to drain the oil from the oil tank.
2
1
1
Advertisement
Table of Contents
